Straight hump, reducer or hump reducer?
It comes down to whether the pipe size changes and how much movement the joint has to absorb. Use a straight hump between same-size pipes that move relative to each other. Use a plain reducer for a short, rigid step in diameter, and a hump reducer where you need the step and the flex in one part.
How do I measure for a reducer?
Measure the pipe outside diameter at each end, and the gap between the pipe ends. Reducers are listed small end to large end with an overall length, so check there's enough pipe for each end to grip and take a clamp.
Can I use these after the turbo?
No. These rubber joints are for the intake side before the turbo. Boosted pipework needs reinforced silicone charge air connectors rated for pressure and heat. Check every rubber joint by hand at filter changes and replace any that feel hard or show cracks.
- Pipe outside diameter at each end
- Overall length and pipe engagement
- Amount of movement at the joint
- Temperature at the position
- Clamp size for each end
Need to change direction too? See 90 degree rubber elbows and 45 degree rubber elbows. Size your clamps at the same time, or ask us to match an old part.
