Outboard Oils (3)

Outboard oils for two-stroke and four-stroke marine engines and the gearcases that drive them. Marine engines work hard: long stretches at high rpm, cooling from cold raw water, damp salty air and weeks sitting idle between trips. Marine oils are certified for those conditions under NMMA ratings, TC-W3 for water-cooled two-strokes and FC-W for four-strokes, which test for corrosion protection and deposit control that a road oil isn't built for.

Start with the engine type and the rating the manual names, then the viscosity. Use an air-cooled two-stroke oil or a car oil in an outboard and you invite carbon deposits, stuck rings, plug fouling and corrosion that only shows when the engine fails. And don't forget the lower unit, which gets its own section below.

Outboard Oils

3 products

  • Valvoline 1104.04 2 Stroke NMMA TC-W3 Outboard Engine Oil 4L
    Vendor:
    Valvoline

    1104.04 2 Stroke Outboard Engine Oil 4L

    1 in stock
    Regular price $52.95 AUD
    Sale price $52.95 AUD Regular price
  • Valvoline 1211.20 80W90 Outboard Gear Oil 20L
    Vendor:
    Valvoline

    1211.20 80W90 Outboard Gear Oil 20L

    2 in stock
    Regular price $299.00 AUD
    Sale price $299.00 AUD Regular price
  • Valvoline 1111.04 4 Stroke 10W40 Semi Synthetic Outboard Engine Oil 4L
    Vendor:
    Valvoline

    1111.04 4 Stroke 10W40 Semi Synthetic Outboard Engine Oil 4L

    3 in stock
    Regular price $51.95 AUD
    Sale price $51.95 AUD Regular price

What do NMMA TC-W3 and FC-W mean?

They're marine oil certifications. TC-W3 covers oils for water-cooled two-stroke outboards, whether premixed or oil-injected. FC-W covers four-stroke outboard oils, and FC-W (CAT) marks oils suited to catalyst-equipped engines. Both include rust and corrosion testing suited to life on the water. Four-stroke outboard oils also need to cope with fuel and water dilution from long idling and short runs, which FC-W testing addresses.

How do you look after outboard gearcase oil?

Change it on the maker's schedule and look at what comes out. Gearcases take a marine gear lube, usually a hypoid gear oil in the grade the manual lists. Milky or creamy oil on draining points to water getting past a seal, which needs fixing before the gears and bearings rust. Metal flakes on the drain plug magnet are worth a closer look too.

Choosing an outboard oil

  • Two-stroke or four-stroke engine.
  • Premix or oil injection, and the mix ratio the maker sets.
  • NMMA rating: TC-W3 for two-strokes, FC-W for four-strokes.
  • Viscosity grade for four-stroke sumps.
  • Gearcase lube grade and fill quantity from the manual.
  • Lay-up: an oil change before long storage removes acids and moisture.

Servicing the whole boat? See marine fuel filters and spin-on fuel water separators, and keep corrosion inhibitors on board. Unsure of the spec? Send us the outboard model.

Which oil does my outboard need?

Match it to the engine type:

  • Two-stroke outboard, premix or oil-injected: 2 Stroke Outboard Oil, NMMA TC-W3, for water-cooled outboards including Evinrude, Mercury, Suzuki and Yamaha where TC-W3 is specified.
  • Four-stroke outboard: 4 Stroke Outboard 10W-40, NMMA FC-W, with vapour-phase corrosion inhibitors that protect the internals while the motor sits between trips.
  • Lower unit or stern drive gearbox: Outboard Gear Oil 80W-90.

Can I use car engine oil in a four-stroke outboard?

Use an FC-W oil wherever your outboard maker specifies one. NMMA FC-W is the marine certification for four-stroke outboard oils and covers the corrosion and sustained high-rpm running that car oils aren't tested for. Valvoline's 4 Stroke Outboard sheet makes the same point the other way round: it's not a passenger car oil and isn't recommended for car engines.

What gear oil goes in an outboard lower unit or stern drive?

An SAE 80W-90 API GL-5 marine gear oil, unless your manual says otherwise. Outboard Gear Oil 80W-90 is a mineral extreme pressure gear oil for outboard and stern drive gearboxes requiring a GL-5 SAE 90, and its sheet lists Mercury, Yamaha, Suzuki, Evinrude, Johnson, Force, Tohatsu, Chrysler and Volvo Penta. Its EP additives are formulated to keep the gears lubricated even with salt water present. We list it in 20L.

Can I use 2 Stroke Outboard oil in my chainsaw or mower?

Yes. Valvoline's sheet says the 2 Stroke Outboard Oil can also be used in air-cooled two-stroke engines such as lawn mowers, chainsaws, brushcutters, edgers and motorcycles. If you only run air-cooled garden gear, Multi-Purpose 2 Stroke (API TC, JASO FB) is made for that job and comes in 1L and 5L. Mix at the ratio the equipment maker specifies.