Choosing a spin-on oil filter
Start from the part number on the old can, then check these specs.
- Filter type: full-flow, bypass and combination cans do different jobs. Fit the same type that came off.
- Bypass valve setting: usually given in psi. A lower setting than the original opens early and sends unfiltered oil round the engine.
- Anti-drain valve: keeps oil in the filter at shutdown. Leave it out where one is specified and the engine starts dry.
- Thread: confirm the head thread exactly. Close enough isn't good enough on a pressurised filter.
- Gasket diameter and can length: a similar-looking can may not seal on your head or clear nearby parts.
What does the bypass valve do?
It opens when the pressure drop across the media gets too high, such as on a cold start or when the filter is overloaded, so the engine never runs short of oil. The trade-off is that oil passing the valve isn't filtered. That's why the setting should match the original, and why overdue filters are a problem: the more loaded the media, the more time the valve spends open.
How to fit a spin-on oil filter
Wipe the head clean and make sure the old gasket came away with the old can. Smear clean oil on the new gasket, spin it on until it seats, then tighten by hand to the filter maker's instructions. Run the engine, check for leaks and top up the oil level.
Engines with a fixed housing take oil filter cartridge elements, and every format sits under oil filters. For a complete service, see heavy duty 4WD service kits, and match the oil from heavy duty diesel engine oils.
