Valvoline Multi-Purpose 2 Stroke is a two-stroke engine oil for air-cooled equipment such as chainsaws, brushcutters, blowers and older two-stroke engines that run a petrol and oil mix. It burns cleanly to keep exhaust ports and spark plugs clear, and carries anti-wear protection for the crank and cylinder. Meets API TC and JASO FB. Supplied in a 5L pack.
Two-stroke oil for air-cooled equipment
In a two-stroke the oil is burnt with the fuel, so it has to lubricate the crank and cylinder and then burn cleanly without fouling the engine. This two-stroke oil is blended for air-cooled equipment such as chainsaws, brushcutters and blowers, burning low-deposit to keep exhaust ports and plugs clear while protecting the internals.
Clean burning and wear protection
The formulation is built to burn low-deposit, which keeps exhaust ports and spark plugs clear, a common cause of poor running and hard starting in air-cooled two-strokes. At the same time it carries anti-wear protection for the crank, bearings and cylinder, which take a beating in a high-revving small engine. It meets API TC and JASO FB.
Getting the mix right
Two-stroke performance depends on mixing the oil with fuel at the ratio the equipment maker specifies, so the engine gets the right amount of lubrication without over-oiling and fouling. Following that ratio is what gets clean running and full protection.
Where it fits
It suits garden, forestry and property equipment running pre-mix two-stroke engines, from chainsaws and trimmers to blowers and older two-stroke machinery.
Mixing and running two-stroke
Two-stroke performance lives or dies by the fuel mix. Always blend the oil with fresh petrol at the ratio the equipment maker specifies, commonly around 25:1 to 50:1, since too little oil starves the engine and too much fouls plugs and ports. Mix in a clean container, shake well, and use the fuel reasonably fresh, as old two-stroke mix separates and goes stale. Clean burning keeps exhaust ports and spark plugs clear, but the correct ratio is what makes that possible. Meeting API TC and JASO FB, it suits chainsaws, trimmers and blowers, and matching the mix to the machine gives clean running and full protection.