Valvoline VPS Heavy Duty DOT 3 is a glycol-based brake fluid meeting the DOT 3 standard, supplied in a 20L bulk container for high-volume workshops. It is the standard-service fluid for hydraulic brake and clutch systems that do not require DOT 4, delivering dependable braking and internal corrosion protection. Bulk supply keeps busy service bays stocked and lowers cost per vehicle.
DOT 3 at workshop volume
For a high-volume workshop, buying brake fluid by the small bottle gets expensive fast. This glycol DOT 3 fluid comes in a 20L container for exactly that reason, delivering dependable braking and internal corrosion protection for systems that do not require DOT 4, while keeping the bays stocked and the cost per vehicle low.
Reliable performance, protected internals
A DOT 3 system is designed around a particular boiling performance, and this fluid delivers it consistently for general road service, so the pedal stays firm under normal driving. Its corrosion inhibitors safeguard the rubber seals and metal internals of the master cylinder, callipers and lines against the internal corrosion that shortens hydraulic component life.
Bulk value and standards
It meets DOT 3, SAE J1703, FMVSS 116 and AS/NZS 1960.1 Grade 1. The 20L pack keeps busy bays stocked and drops the cost per vehicle noticeably across a week of brake work, decanting cleanly into a dispenser or brake bleeder.
Where it fits
It suits automotive workshops and fleet servicing carrying out DOT 3 brake fluid changes at volume. Where a vehicle specifies DOT 4, use a DOT 4 fluid, and confirm the grade before service.
Bulk handling and change intervals
A 20L container is efficient for a busy workshop, but it does mean managing moisture: keep the container sealed between uses, since glycol fluid absorbs water from the air, and draw off through a clean dispenser or brake bleeder rather than leaving it open. A scheduled fluid change every couple of years keeps each vehicle's boiling point up and slows corrosion. Keep the fluid off paintwork, and never mix a silicone DOT 5 product into a glycol system. Where a vehicle specifies DOT 4, use DOT 4 rather than DOT 3. Managed this way, bulk supply keeps the bays stocked and the cost per vehicle low.