Valvoline Heavy Duty DOT 3 is a premium glycol-ether brake fluid for hydraulic brake and clutch systems that specify a DOT 3 fluid, packaged in a 500ml top-up bottle. Formulated with advanced inhibitors, it delivers reliable boiling performance for everyday braking while protecting rubber components and metal surfaces from corrosion.
A dependable DOT 3 for general service
A DOT 3 system is designed around a particular boiling performance, and this premium glycol-ether fluid is formulated with advanced inhibitors to deliver it reliably for everyday braking. Just as importantly, it protects the rubber and metal it runs through, guarding the master cylinder, callipers and lines against internal corrosion.
Consistent braking, protected internals
Brake fluid has to stay incompressible to give a firm pedal, which means resisting the heat that braking generates. This fluid delivers the stable boiling performance a DOT 3 system is designed around, so the pedal stays consistent under normal road driving. Its corrosion inhibitors protect the rubber seals and metal surfaces inside the master cylinder, callipers and lines, guarding against the internal corrosion that shortens the life of hydraulic components.
Meets the standards
It meets DOT 3, SAE J1703, FMVSS 116 and AS/NZS 1960.1 Grade 1, the specifications a DOT 3 brake and clutch system calls for. The 500ml bottle is sealed and sized for bleeding and top-ups on a single vehicle.
Where it fits
It suits passenger cars and light vehicles that specify a DOT 3 brake and clutch fluid. Where a vehicle calls for the higher boiling points of DOT 4, use a DOT 4 fluid instead, and always confirm the required grade before topping up.
Why brake fluid needs changing
Being hygroscopic, DOT 3 fluid absorbs moisture from the atmosphere over time, which lowers its boiling point and encourages corrosion inside the master cylinder, callipers and lines. Manufacturers therefore call for a periodic fluid change, typically every two years, independent of how far the vehicle has travelled. Use fresh fluid from a sealed bottle when bleeding or topping up, avoid contact with paintwork, and do not mix a silicone DOT 5 fluid into a glycol system. Where a vehicle specifies DOT 4, fit DOT 4 rather than stepping down to DOT 3. Sticking to the correct grade and change interval is what keeps braking consistent and the hydraulic system sound.