A 15 m run of 3/4in oil-filled rubber hose that will not rewind cleanly becomes a trip hazard and a daily frustration in a working bay. The RAASM 8540.411 is the 540 Series spring-rewind reel built to keep that hose managed and higher-flow oil moving.
The reel runs an open, spring-rewind mechanism on a painted steel reel and frame, fitted with 15 m of 3/4in black rubber hose. The spring is what carries the weight of a full oil-filled hose back onto the drum, so the line is retracted and off the floor between jobs rather than left underfoot. The 3/4in bore is sized for higher-flow oil transfer, which means less time waiting on delivery at each service point than a 1/2in reel gives you, and it is the reason to choose this reel over a narrower one when throughput matters.
It is rated to a maximum working pressure of 100 bar (10,000 kPa / 1,450 psi), comfortably above typical workshop oil distribution pressures, so the reel is not the limiting part of your dispensing line. What decides whether a reel lasts is the swivel and the seals. This one uses a zinc-plated steel swivel joint and polyurethane seals specified for oils and similar fluids. That matters because generic seals are the common failure point on under-specified reels, and a seal that is not rated for petroleum oil is what causes early weeping and swivel wear that ends up costing more than the reel saved.
Fluid rated for oils and similar products, including fresh oils and antifreeze. The inlet is G 1in (female) and the outlet is G 3/4in (male). Australian workshop plumbing is typically BSP, so standard installations connect without an adapter. Confirm your supply line terminates in a male BSP fitting before ordering.
The 8540.411 is a fixed-base reel, the right choice for a permanent dispensing point rather than a mobile setup. It suits a wall, ceiling, floor, or tank and gantry mount, keeping the hose clear of damage and the bay clear of clutter, and it earns its place in agriculture and earthmoving for fast top-ups, in fleet workshops for consistent dispensing and cleaner bays, and on mining and industrial sites where rugged handling and controlled hose management matter.
To complete the installation you supply the mounting surface and a supply line ending in a male BSP fitting. The reel comes fitted with the 15 m hose but does not include a dispensing gun, so an oil control gun or a digital metered gun is needed to finish a job-costed dispensing point. If your runs are longer than 15 m, the 20 m version in the same 540 Series is the one to step up to, so measure the distance from your mounting point to the furthest machine before you decide.